When you’re unfortunate enough to find a mold growth problem in your house, whether it’s in the basement, attic, or on the wall of your bedrooms or lounge, it’s imperative that you deal with the problem right away. Although small mold spots may be managed using DIY techniques wide areas have to be properly inspected and treated due to the possible health risks involved.
You would need to get a mold inspection performed by a trained professional to assess the type of mold present and the type of repairs that will have to be undertaken. A note of caution: there are numerous inspectors for molds out there but it is important that you are not tempted to pick one simply because the cost is small. It is a potentially dangerous situation and the best you can do is just to hire.If you wish to learn more about this, visit Water Mold Fire Restoration of Boca Raton.
Which, then, is all about a mold inspection? A mold inspection can detect any conditions that promote mold growth around your property as well as identify problem areas such as water damage, odors and apparent signs of fungal growth etc. For obvious signs of water damage, leaks and their origins such as damaged pipes, damaged gutters, cracked brick work etc., the mold inspector will take the inspection outside and test the dwelling ‘s exterior again.
Who is exactly the inspector doing during a mold inspection?
The first task after the initial visual tests is usually to gage the levels of moisture present in the property’s walls. The moisture levels are assessed at intervals of approximately two feet, and the inspector will pay particular attention in areas under sinks, around water heaters, anywhere there is a water source present. The levels of moisture are measured using a special meter which has two small pins inserted into the lower part of the wall which will provide a reading to indicate the level of moisture. The appropriate standard is at or below 15 per cent.
If your inspector detects wall moisture readings that are greater than the appropriate amount at this point in the mold inspection, or finds signs of water damage or mold growth, he / she will bring them to your attention and probably discuss whether samples should be taken. But, even though there are obvious stains caused by water damage or maybe mold growth the inspector would still be unable to give any indication for certain that you have a mold problem which is why sampling is important.
Most certainly, the sample taken is an air sample. It is possible to determine what strain of mold is present in the atmosphere and in what quantities by taking air samples during a mold inspection. At this level, I must point out that the mold inspector will take at least two samples of the air. The first should be from the troubling field and the second should be from outside. To take an outside sample? The response to that is clear. Mold is found everywhere, we breathe it all the time, and for the most part it’s 100% healthy and it doesn’t affect us anyway. Therefore, it must be determined during a mold inspection whether or not the inside mold is the same strain as the outside strain, and whether it is in the same ratio or less. Clearly, the other side of the coin is that the amount of mold may be the same but the internal concentrations may be much higher, or it may be toxic mold.
Where visible mold growth samples of this can also be taken allowing for the detection of the particular form of mold spores, but this does not decide whether or not such mold spores are in the air.
How quickly can you be expecting results?
Such samples that take 3-4 days to process in the laboratory as a rule of thumb, but I would certainly expect the mold inspector to make contact and send a verbal report as soon as the results are available followed by a written report within a few days. An additional factor to be aware of is that a good mold inspector would not actually give you a copy of the laboratory report when it comes to the report following a mold inspection. He / she must be able to interpret the findings with confidence and give them along with advice to solve the problem in plain English!